|
MINI PRO PEG – INSTALLATION INSTRUCTIONS
HAVE A PROFESSIONAL WELDER INSTALL FRONT AND REAR NERF BAR
MOUNTING TUBES
·
Remove stock floor boards or foot pegs from
machine. Mark above on the chassis or plastic side cover using masking
tape of the central point of the stock foot peg, specifically for a
comparison.
·
At this point ask your rider to sit on the
machine. Have the rider hold their feet where they would prefer the new
foot peg to be. Most riders should feel comfortable at or slightly behind
the stock foot peg location. Mark above on the chassis or plastic side
cover using masking tape of the central point the riders preferred
position. This mark is approximately perpendicular to where the rear tube
will be mounted.
·
Install heel guards onto the rear of the
Nerfbars using supplied hardware, after installation is complete check for
clearance of the rear tires. Make sure you are not mounting to far forward
to prevent rubbing on the front tires and/or causing the machines center
of gravity to be to far forward.
·
To save electrical problems completely unplug
your CDI unit.
·
Once you are satisfied with the location of
your foot peg, and this area has been marked on both sides, start with the
steel rear mounting tubes. Remove all paint from the mounting point, as
well as at least a ˝” around this point. Measure 9 ˝” forward on the frame
from the center of your rear tube to find the center point of the front
mount location.
·
When welding remember to weld completely
around tube. Tubes should remain level with chassis.
·
To adjust stance width, cut aluminum tubes to
desired length. Slide the Nerfbars onto the steel pegs as far as possible.
Drill a hole completely through the mounted Nerfbars, through the mounting
tube and out bottom, using a 1/4” drill bit. Pass the supplied bolts
through the hole and “lock-tite” the nut on. Drill all 4 tubes. Drilling
may be easier from underneath, stand the machine on the rear grab bar to
easily access the bars from underneath.
·
Net Installation – Run the net down through
the top, out the bottom, back up through the middle and out the top,
underneath other strap. Leave minimal slack.
|
