HIGH REV CDI WIRING CHART
Red/White-----TO-----Stator
R/W
Black/Red-----TO-----Stator B/R
Black/White-----TO-----Killswitch
Black-----TO-----Chassis Ground
Orange-----TO-----Coil
***ETON AND OTHER ATV’S WITH
RUBBER MOUNTED COIL ONLY***
Orange-----TO-----Green Side of Coil
Run separate wire from Chassis Ground-----TO-----Black Side of Coil
Run another ground wire from chassis to
engine!
Tape off remaining stator wires!
|
CDI/WIREING |
|
Q: If I install your CDI will the electric start still
work?
A: Yes, the ignition and the starting/charging system
are completely different systems. If electric start does not work
after installation, wires are installed wrong. This setup will only
eliminate their stock shut off switches. |
|
Q: If your CDI eliminates their stock shutoff switches,
how do I shut my quad off?
A: This is where the required Pro Design Tether Kill
Switch comes into play. |
|
Q: What do I do with extra wires?
A: Sometimes there will be extra wires off the ATV that
you will need to just tape off, they will remain unused. Double check
the wiring diagram. This will not cause damage. |
|
Q: Why won’t my quad start after I wired up your CDI?
A: The most common mix-up is the black/white wire; this
is the wire that changes the system. Unplug it and see if it starts.
This is where the killswitch wires into. |
|
Q: How do I wire in the orange and black wires with the
connector on them?
A: Two ways,
1st- From the stock Wiring harness there is a
connector that it will easily plug in.
2nd- Cut the connector off of the new CDI and add
wire for length and solder the orange wire to the coil wire. Than
ground the black wire to chassis ground. |
|
*** THE CDI MUST BE WIRED UP EXACTLY AS THE INSTUCTIONS
SHOW. |
|
