Hetrick Racing National Pro-Peg Nerf Bar Installation Instructions

HAVE A PROFESSIONAL WELDER INSTALL FRONT AND REAR NERF BAR MOUNTING TUBES

·         Remove stock floor boards or foot pegs from machine.  Mark above on the chassis or plastic side cover using masking tape of the central point of the stock foot peg, specifically for a comparison.

·         At this point ask your rider to sit on the machine. Have the rider hold their feet where they would prefer the new foot peg to be. Most riders should feel comfortable at or slightly behind the stock foot peg location.  Mark above on the chassis or plastic side cover using masking tape of the central point the riders preferred position. This mark is approximately perpendicular to where the rear tube will be mounted.

·         Install heel guards onto the rear of the Nerfbars using supplied hardware, after installation is complete check for clearance of the rear tires. Make sure you are not mounting to far forward to prevent rubbing on the front tires and/or causing the machines center of gravity to be too far forward.

·         To save electrical problems completely unplug your CDI unit.

·         Once you are satisfied with the location of your foot peg, and this area has been marked on both sides, start with the steel rear mounting tubes. Remove all paint from the mounting point, as well as at least a ½” around this point. Measure 9 ½” forward on the frame from the center of your rear tube to find the center point of the front mount location.

·         When welding remember to weld completely around tube. Tubes should remain level with chassis.

·         To adjust stance width, cut aluminum tubes to desired length. Slide the Nerfbars onto the steel pegs as far as possible. Drill a hole completely through the mounted Nerfbars, through the mounting tube and out bottom, using a 1/4” drill bit. Pass the supplied bolts through the hole and “lock-tite” the nut on. Drill all 4 tubes.  Drilling may be easier from underneath, stand the machine on the rear grab bar to easily access the bars from underneath.

·         Net Installation – Run the net down through the top, out the bottom; back up through the middle and out the top, underneath other strap. Leave minimal slack.